Activity Stream
-
Older Activity
-
06-06-2024, 05:13 PMhello, do you 3dprint this table with double nozzles priter, or just it 3dprinted whole table and stick to the foil with markers? Which technique...40 replies | 169648 view(s)
-
06-06-2024, 05:09 PMHi All,anybody try to scan markers with Einscan SP? Only 3mm markers can be worked for markers? I stick 0,8mm markers, but the scanner do not...40 replies | 169648 view(s)
-
06-05-2024, 07:31 AMPLAyer_uno started a thread Blue screen of death after thermal runaway - fried motherboard? in General 3D Printing DiscussionHello all, While cleaning the hot end on my Ender 3, with the printer was on and the hot end at 215C, I must have accidentally caused a short...0 replies | 476 view(s)
-
06-04-2024, 09:14 AMBikeracer2020 replied to a thread Holes and pockmarks in print walls in General 3D Printing DiscussionLooks like some under extrusion there. Possibly a gap between the end of the bowden tube and the new nozzle, the bowden tube needs cutting square...1 replies | 423 view(s)
-
06-04-2024, 05:50 AMHello, I'm new to 3d printing and this is my first post here. Recently bought an old Ender 3 with 1 partially used roll and 1 new packaged rool of...1 replies | 423 view(s)
-
06-03-2024, 02:23 PMImpressive articulated amazon parrot by biologist artist Arara on cults: https://cults3d.com/en/3d-model/art/amazon-parrot-articulated-figure0 replies | 549 view(s)
-
06-02-2024, 01:14 PMHi everyone, I'm new to the forum. I have an opportunity to get a pre-owned Lulzbot TAZ Pro. I've been looking online to get an idea of what the...0 replies | 623 view(s)
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion