Command M302 allows cold extrudes.
Type: Posts; User: Poindexter
Command M302 allows cold extrudes.
There is a work-around to access the the two servo pins that are blocked by the fan extender. You can solder wires to the solder points on the fan extender board above the pins that aren't being...
I'm having difficulty setting my pot for one of the steppers. It is either too low and the motor skips or it is too high and I get an intermittent response from the motor. The other stepper driver...
Is there any benefit in having the print fan running during preheat? Thats how my printer was configured during the test prints. Is it meant to reduce oozing?
Thanks for the work around C42, as well as the new site. Time to get this thing running 100%.
Thanks Roxy. Also, when powering the servo from the AUX-2 pins, do I need the signal wire on D40 and the pos/neg wires plugged in on the two top pins? The AUX-2 schematics look a bit more convoluted...
Hey everyone,
I'm having some trouble with getting the servo to respond. My setup is as follows: RRD fan extender from makerfarm (D4 and 5 pins?). D5 is set to auto cool when hotends are above 35,...
C42, thanks for the hardware kit. Very fast shipping and a "gift" in mine as well. I'm new to the 3d printing community so I'll try not to newb it up. With a name like mine you'd expect me to have a...
- What is the most interesting thing you have seen done with a 3D printer or 3D printing technology?
3d printed prosthetics are the most interesting and life changing creations to come from this...