PLEASE! I need help with my Ender 3.

[Madda]

Sorry i have been busy with the holiyday.


I tried https://www.youtube.com/watch?v=_EfWVUJjBdA. After i painted the bed, so the print would stick and it started out great but some lines were thin and evantely stuck to the nozzle.

I tried paint a boat and this was the results before i had to stop the printer. The first layer was great but as soon as it sped up it became like the pic below.

Also it looks like the lines don't merge on the first layer to make a solid surface.
20181225_120619.jpg20181225_120628.jpg20190108_183430.jpg20190108_183517.jpg20190108_183713.jpg

Roberts_Clif can you explain the names of your files for example "Hictop 1.75 Profiles 30" what dose the last nummber stand for?

[Roberts_Clif]

Roberts_Clif can you explain the names of your files for example "Hictop 1.75 Profiles 30" what dose the last number stand for?

I have profiles from 05 - 30 this is the layer height.

What layer height are you using.

I see you have

• Ender-3
• PLA 1.75mm 200C
• Glassbed 70C
• Steel nozzle 0.4

[Madda]

Im using Coarse - 0.4mm.

It's the same size as the nozzle isn't that what's it's for?
As it prints the first layer shouldnt the PLA stick together creating a solid surface?

How do i install your files btw? Cura seams to not like them. Should i put them in manualy?