Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 26

Hybrid View

  1. 10-28-2015, 10:58 PM #1
    KMToydarian
    KMToydarian is offline
    Student
    Join Date
    May 2014
    Posts
    16
    Quote Originally Posted by hsus View Post
    Read about Cura that you need to set up your printer's profile with settings for that specific printer. Is this something you needed to do? If so, mind sharing?
    Somewhere else, maybe the new matter website support? they said to email them and they will send you a Cura profile. They sent it to me this afternoon, but I haven't looked at it yet.
    Reply With Quote Reply With Quote
  2. 10-29-2015, 06:43 AM #2
    dshapdesign
    dshapdesign is offline
    Student
    Join Date
    Oct 2015
    Location
    Buffalo, New York
    Posts
    2
    Quote Originally Posted by KMToydarian View Post
    Somewhere else, maybe the new matter website support? they said to email them and they will send you a Cura profile. They sent it to me this afternoon, but I haven't looked at it yet.
    Would you mind posting it on a thread here?
    Reply With Quote Reply With Quote
  3. 10-29-2015, 12:27 PM #3
    Robotico
    Robotico is offline
    Student
    Join Date
    Mar 2015
    Location
    California
    Posts
    10
    Quote Originally Posted by dshapdesign View Post
    Would you mind posting it on a thread here?
    http://support.newmatter.com/custome...-faqs/articles
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules