Second impression:
Second test print worked like a charm. New Matter replied saying that if I leave the clear enclosure off (which I had done) the space can be too cool and cause problems with the print not adhering to the bed. So from now on I keep the lid on.

They also said that the louder than expected calibration routine was probably due to the bed being slightly crooked on the rods. Got the second print I got it on straight and it was much quieter.

At the beginning of the second print when it "wipes its nose" on the side of the bed, it still strung a very fine line of filament to the print area and it stick under the print. Is this normal?