Got mine today - First Impressions

[JCrump]

i just got mine. went through the setup process with out a hitch. as soon as i started the test print also noticed the head is sitting too high above the build plate.. therefore it refuses to print anything properly. sounds like the same issue as you.

Actually, the head was above the print bed only because I had remove the partial print and then tried to resume. Kind of stupid on my part.

[drewdsu42]

Actually, the head was above the print bed only because I had remove the partial print and then tried to resume. Kind of stupid on my part.

I had 4 failed test prints before mine started behaving. Now I have 2 100% successful prints.. And I'm notlw printing an stl file that I uploaded..

So far so good... But there are an awful lot of supports...
Gonna be a pain to remove...
http://imgur.com/a/Hcn1q

Also my print bed is starting to warp a bit.. Made the extruder head get stuck and now I have some permanently indented marks on the build plate from the head