Trouble keeping PLA print from falling over

[pochrist]

Just an update: I was overheating because I thought my room was too cool and getting desperate. It turns out my printers z axis is "drifting" upwards on one side. I corrected it and re-leveled the bed and moved the nozzle closer to the bed as well (0.1mm) and now it runs perfect. Have to keep an eye on the "z" axis though after a few prints it seems to drift up about 2-3mm higher on max X side of the bed.

[Todd-67]

Just an update: I was overheating because I thought my room was too cool and getting desperate. It turns out my printers z axis is "drifting" upwards on one side. I corrected it and re-leveled the bed and moved the nozzle closer to the bed as well (0.1mm) and now it runs perfect. Have to keep an eye on the "z" axis though after a few prints it seems to drift up about 2-3mm higher on max X side of the bed.

That's good to hear. Sometimes we start making changes that we start going down a rabbit hole and loose sight of the starting points. Glad you got it figured out.