Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 10-17-2015, 04:24 AM #1
    Mjolinor
    Mjolinor is offline
    Senior Engineer
    Join Date
    Jun 2014
    Location
    Burnley, UK
    Posts
    1,662
    It cannot be done like that. The whole Gcode is geared to the amount that is extruded at any instant, it has to be in the Gcode as far as I can see anyway.

    Fit the same size nozzles to all the machines.
    Reply With Quote Reply With Quote
  2. 10-17-2015, 04:36 AM #2
    DBFIU
    DBFIU is offline
    Banned
    Join Date
    Jan 2015
    Posts
    306
    Quote Originally Posted by Mjolinor View Post
    It cannot be done like that. The whole Gcode is geared to the amount that is extruded at any instant, it has to be in the Gcode as far as I can see anyway.

    Fit the same size nozzles to all the machines.
    I tried, the nozzles are different by such a small amount that I can visually tell the difference. I get a 5 pack of 0.5mm nozzles from china and some of them overextrude badly. I need to get 0.4mm and drill them out with my 0.5mm drill bit but even then its not exact.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules