Another Sintratec kit built

[rudschul]

i think the most importent thing is that you have an object that you could measure. Try to get first a nearly good print and than try to adjust the x,y,z. With the grid have an orientation. Try the folowing values:
heat up: chamber 149,5 surfarge 166
printing: chamber 150 surfage 170,5
speed 550

These values are not perfect but a good starting point.

[rudschul]

yes this is important:

The frontal light shade has to be adjusted correctly. the shade of has to be aligned exactly to the backside.

You remember the L-Peaces near the lamps. The L-Peace of the front lamp makes the shadow. You can loosen the screw and move the L-peace