CTC Problems or 3D newbie problem.

[EagleSeven]

I had problems trying to use latest version of Makerware, also,
I'm using version 2.4 that came with printer.
All other Slicer software I've tried has had some kind of compatibility problem,
so had to go back to 2.4.

I've never changed firmware, so don't know about Sailfish, Sorry.

Were the temp settings working correctly before you changed the Firmware ?

[BlackMist]

Hello...

the problem about the temp i think is beacuse of the pre heating settings that is set by default to 230 for extruders and 110 for the bed on sailfish 7.7 im goind to put all to zero and see if i can control the temp. with makerware...

But now i have a some doughts about bed leveling... as ive read about you have to use a piece of paper... so... i get the extruder to front center and level the bed until it scratchs the paper... do the same to left... then right side... but when i go back to front center i dont feel the scratch on the paper... is that normal? the same happens at the back.... for me to feel some grip at center the left or right is too tight!

I had problems trying to use latest version of Makerware, also,
I'm using version 2.4 that came with printer.
I've never changed firmware, so don't know about Sailfish, Sorry.

Were the temp settings working correctly before you changed the Firmware ?