Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 12

Hybrid View

  1. 10-19-2020, 03:28 PM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,153
    Add Roberts_Clif on Thingiverse
    You were printing with ABS an then switched to PLA.

    Did you Purge the ABS from the hot-end by running PLA to the ABS temp and Pushing Extra ABS from the Hot-End.
    Reply With Quote Reply With Quote
  2. 10-19-2020, 05:13 PM #2
    dup
    dup is offline
    Student
    Join Date
    Oct 2020
    Posts
    6
    Quote Originally Posted by Roberts_Clif View Post
    You were printing with ABS an then switched to PLA.Did you Purge the ABS from the hot-end by running PLA to the ABS temp and Pushing Extra ABS from the Hot-End.
    I'm pretty sure I did - heated it up to 240 C, removed the ABS filament, then pushed the PLA filament through the extruder so that it (should've) caught all the remaining ABS.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules