Pegasus 12" Build Notes

[uncle_bob]

Hi

Ok, here's a picture

(image *should* have been here but it isn't ....)

223_ - 1.jpg

It's a shot of the foot I decided to use. I fiddled around a lot and ultimately decided on a pretty simple design.

Let's see if the image goes through or not. The "post image" button didn't seem to do much.... Drag and drop also did not work. Try again with a *really* small file ... finally it works.

Next up is the "custom" bed mount piece

224_ - 1.jpg

That is a bit higher resolution than the first one so this is a bit encouraging. The mount piece lets the heater "float' when there is no glass. Put another way, the clamp holds both the glass and the heater in place. That way as the PCB changes size during warmup, things don't move all over the place.

Bob