PETG Filament when resistance to cracking is necessary?

[EagleSeven]

Just ordered two spools of eSUN PETG. I found PLA to work pretty d a r n good. Only complaint was it was just a bit brittle.
If PETG is any better I'm going to be in print heaven.

I got the PETG filament today and I printed a camera-holder, for first try, and it did Great !
(nozzle-temp @ 200C & bed-temp @ 70C)
I printed a camera-holder since it had a long bridge opening , about 36mm.
I wanted to see how well it did across gaps
and I was surprised how well it bridged the gap, with only one loose pass !
It seems very strong and flexible also.

I was surprised at the rough feel of the PETG filament, compared to other filaments,
almost like it has sand in it, but No problems out of nozzle !

[Ward]

I got the PETG filament today and I printed a camera-holder, for first try, and it did Great !
(nozzle-temp @ 200C & bed-temp @ 70C)
I printed a camera-holder since it had a long bridge opening , about 36mm.
I wanted to see how well it did across gaps
and I was surprised how will it bridged the gap, with only one loose pass !
It seems very strong and flexible also.

I was surprised at the rough feel of the PETG filament, compared to other filaments,
almost like it has sand in it, but No problems out of nozzle !

Thanks for this update. Very helpful.

What printer was this on?

[EagleSeven]

Thanks for this update. Very helpful.

What printer was this on?

Our printer is a CTC-Bizer, as pictured in my avatar pic