Quote Originally Posted by curious aardvark View Post
My problems are simply getting things to stick to anything without a raft. Not sure if it's me or the software.
for the vast majority of prints - rafts are just not suitable as removing prints from them can be nigh on impossible.
I never print with rafts and no issues with model unsticking, but then again, I never use pure Kapton

I use either office glue like UHU Stick or dissolved PVA. For ABS (which I slowly abandon in favor of taulmann nylon) I use ABS juice and re-calibrate the bed on 110degC temperature (cause it warps more at those temps).

The only problems I get is the models sticking to the bed too well But you can use lighter butane refills to get them off (temperature shock) or pry them off with a snap-off knife (that works brilliant most of the time). You also get a perfect glossy surface on the bed side of the print.