MakerFarm 8" i3v Prusa build by Printbus

[AbuMaia]

The RAMPS and heater relay were mounted in the provided holes. I threw spacers on these too, mainly so I could tuck wires under the boards.

Attachment 1517

Huh, so that's what those holes are for. My heat bed relay melted when I was still using the i3, and I haven't fixed it yet. I've been using the relay mount holes as a place to zip-tie up the cables for the heat bed.

[printbus]

Huh, so that's what those holes are for. My heat bed relay melted when I was still using the i3, and I haven't fixed it yet. I've been using the relay mount holes as a place to zip-tie up the cables for the heat bed.

Yep. I can't speak to the i3, but the i3v build guide mentioned that's what the small hole pattern was for. The frame could stand a few holes for adding zip ties at both the RAMPS and heater relay; I thought about drilling some but ended up using 1/4-inch cable clamps instead.