Projet 1200 - FTX Cast Burnout Tests

[G.EVE]

Been having issues with incomplete prints. Random areas seem to be delaminating. Seems like it's sticking to the bottom. Not sure why this is happening or how to fix it. This is occurring to more than half of my prints. Large or small supports don't seem to make any difference. There doesn't seem to be any way of changing things like print speed, layer thickness, etc. in the software. Not sure what to do.

IMAG0507.jpg


EDIT: No updates on software or firmware recently that would have caused it.

hi
you can try magic and fix your naked edge or anything else that may cause if fail //// maybe its not bolin

[bford903]

hi
you can try magic and fix your naked edge or anything else that may cause if fail //// maybe its not bolin

Magic, eh? Been a while since I talked to the coven. I wonder if they still have my wand...

Pretty sure there aren't any naked edges or bad surfaces on the model. Usually, if there's a bad surface or naked edge on the model, the problem areas occur in the same spot every print, in the vicinity of the bad surface or naked edge. I don't think that's it but I will double-check with a few third-party programs just to make sure.

Bolin? Do you mean Boolean? Yes I used the Boolean Union command in Rhino to make the model into one watertight mesh for printing.