i need help badly

[crazymonke42]

so i lossened the bolt that was holding the thermistor and plugged it back in and it is reading 26 also it is putting out filament now

[crazymonke42]

the filament did not look very melted though

[Roberts_Clif]

the filament did not look very melted though

so i loosened the bolt that was holding the thermistor and plugged it back in and it is reading 26 also it is putting out filament now

Is this a different filament that you have never used before?
Which filament are you using?
How old is the filament?
How was the Filament stored?
What temperature was the Hot-End set?

[Roberts_Clif]

Here is a setup for the Model below

[Roberts_Clif]

Using Cura load a temp tower like this one on thingiverse
https://www.thingiverse.com/thing:2493504

Then Using tweak At Z-3.0.1 with Cura I find where the layer temp increase and using that layer enter in tweak At Z-3.0.1.
This means that I will be using 8 tweak At Z-3.0.1 for the 8 temperature changes.

The temperature is usually printed on the roll of filament.
On My machine I print PLA between 196- 206
Though printing a temp tower will show you the best filament temperature.