Results 1 to 8 of 8
Thread: Heated Bed Not Heating.
Hybrid View
-
06-06-2016, 09:32 PM #1
- Join Date
- Jul 2014
- Posts
- 305
-
10-04-2016, 12:51 PM #2
- Join Date
- Nov 2014
- Posts
- 58
i just built a pegasus for a friend and notice that too. the bed comes with a automotive relay. but from past experiences this big beds goes up and down a lot when not using PID TEMPs .
i was wondering is you can post a picture of what contacts you jumped. i dont have a multimeter in hand so will be very helpfull for in order to install the SSR.
thanks
-
10-05-2016, 08:19 PM #3
- Join Date
- Jul 2014
- Posts
- 305
http://imgur.com/LHksYTw
Hopefully this helps. I have removed the smaller wires that were used for the relay. Instead I have it hooked up through my PSU and the SSR. The small wire you see is for the bed sensor.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion