Subscribe to Our Newsletter Advertise
Close



Results 1 to 5 of 5

Hybrid View

  1. 08-14-2022, 06:53 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,154
    Add Roberts_Clif on Thingiverse
    It appears that your nozzle is a little to high above the bed. Adjust using Z-Offset.
    Reply With Quote Reply With Quote
  2. 08-15-2022, 01:03 PM #2
    DougCa
    DougCa is offline
    Student
    Join Date
    Aug 2022
    Posts
    2

    Thank You!

    Quote Originally Posted by Roberts_Clif View Post
    It appears that your nozzle is a little to high above the bed. Adjust using Z-Offset.
    That worked perfectly, I had to download the plug-in for Cura but I found it, set it -0.2 and that did the trick. I really appreciate the help! Just curious, is Cura the best low cost or free slicer out there or do you prefer a different program?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules