Anyone recognize this motor?

[Mjolinor]

Well I have found the two pairs of pins that show resistance, on my new motor. I will pull off my old motor and check that also.

My main question is the wiring. Do the two pairs or A and B have to be wired to a matching A and B from the old motor? Like A to A and B to B or can I swap them around?

If A and B are swapped on one coil then the motor will run the other way round. If they are swapped on both coils it will be OK. If you do not wire correctly and swap a terminal from coils one and two then the motor will not do anything.

[BLKKROW]

If A and B are swapped on one coil then the motor will run the other way round. If they are swapped on both coils it will be OK. If you do not wire correctly and swap a terminal from coils one and two then the motor will not do anything.

Then is there a way to differentiate A from B?

[Mjolinor]

Then is there a way to differentiate A from B?

It is not possible without some serious testing gear and it is not necessary, if it rotates the wrong way then reverse one pair.

[BLKKROW]

It is not possible without some serious testing gear and it is not necessary, if it rotates the wrong way then reverse one pair.

Cool thank you!

[BLKKROW]

It is not possible without some serious testing gear and it is not necessary, if it rotates the wrong way then reverse one pair.

Thank you thank you thank you!

After some quick work the new motor is in and working perfectly!