ABL Servo probe bumps into bed before raising to next location

[adamfilip]

I do have raise between Probings already set
but right now, it tried to retract before doing any Z moves.
and it should be the other way around.

I will read more about that thread link, lots of interesting items talked about

[Roxy]

I do have raise between Probings already set
but right now, it tried to retract before doing any Z moves.
and it should be the other way around.

I wonder if you are looking at it wrong? The G28 and G29 are separate commands and not used in the normal operation of the printer. If the printer is not probing, any movement of the Z-Axis should be done with the probe retracted. For G28 and G29 an exception has to be made and the probe is put down. But at the start and at the end of each of these commands the Z-Probe should be retracted. Right?