MASSIVE Contest - Coming Soon!

[Geoff]

What would you guys like to see as far as methods of entering the contest? We should have several dozen prizes, including 3D printers.
I plan to run the contest for a few months.
Eddie

Painting 3D prints!! I have about 90 entries..

[Roxy]

Painting 3D prints!! I have about 90 entries..

I agree!!! And if there is a Delta Printer in the mix, that should be awarded to the best Firmware Enhanced 3D Printed piece.

All joking aside:

I would strongly encourage... that almost without exception... Nothing wins unless it is submitted with full source code.

[Geoff]

I agree!!! And if there is a Delta Printer in the mix, that should be awarded to the best Firmware Enhanced 3D Printed piece.

And I would add, that almost without exception... Nothing wins unless it provides full source code.

oooh Delta printer... they look flashy don't they!

[Roxy]

oooh Delta printer... they look flashy don't they!

They way they move.... They can really benefit from and leverage firmware improvements! If that were to be a category, that would be the right reward for it.

[Geoff]

They way they move.... They can really benefit from and leverage firmware improvements! If that were to be a category, that would be the right reward for it.

for sure.. they are hypnotic. I wonder what it's like printing on that round heatbed... so far everything I have seen form them is pretty impressive, even the clones look sexy.

[Roxy]

for sure.. they are hypnotic. I wonder what it's like printing on that round heatbed... so far everything I have seen form them is pretty impressive, even the clones look sexy.

Too be sure they are hypnotic. But what nobody has done yet with the slicing programs is deliberately not keep the nozzle pointed straight down. With the right firmware (and slicer) the Delta Printers should be able to work straight out at a much steeper angle (without support material).