[Problem] Ender 3 Pro Z-Axis not moving while Autohome

[Roberts_Clif]

It appear that it thinks it is already at a Z-Axis of zero, this could be why it will not travel down.

Check to see is a M119 says that the BL-Touch is already sensing that you are at Zero.

[V00D00]

It appear that it thinks it is already at a Z-Axis of zero, this could be why it will not travel down.Check to see is a M119 says that the BL-Touch is already sensing that you are at Zero.

I did. It says the thing below


[...]
Send: M119
[...]
Recv: Reporting endstop status
Recv: x_min: open
Recv: y_min: open
Recv: z_min: TRIGGERED
Recv: ok
[...]


I read several topic on the internet about this issue but can't figure out a working solution.I never changed any wiring of my BLTouch neither changed something in Marlin. It worked like a charm before cutting of the PINs on the backside.I don't understand. I'm really frustraded about this right now.