I apologize for my poor translation of the English language. I use google. I'm from the Czech Republic and nobody wants to advise me here.

1. I bought a Creality Ender 5 plus
2. I want to replace the original board with a 32bit board.
3. I want to buy this board S6 V2.0 Board 32 Bit Control Board Support 6X TMC Drivers Uart / SPI Flying Wire XH / MX Connector VS F6 V1.3 SKR V1.3
4. Here on this page: https://www.aliexpress.com/wholesale? CatId = 0 & initiative_id = SB_20210311063519 & SearchText = TMC2226 + V1.0

There are 4 types of TMC2226 drivers:

(1) BIGTREETECH TMC2226 V1.0 UART Stepper Motor Driver 3D Printer Parts TMC2209 TMC2208 SKR V1.3 SKR V1.4 MINI E3 For Ender 3 CR10

(2) BIGTREETECH TMC2226 V1.0 Stepper Motor Driver Stepstick Mute 3D Printer Parts For SKR V1.3 SKR V1.4 Turbo Pro MKS 3D Motherboard

(3) BIGTREETECH TMC2226 V1.0 Stepper Motor Silent Driver VS TMC2209 / 2130 Driver For SKR V1.3 / V1.4 / V1.4 Turbo MKS 3D Printer Parts

(4) BIGTREETECH TMC2226 V1.0 Stepper Motor Driver UART 3D Printer Parts vs TMC2209 TMC2208 For SKR V1.3 V1. 4 Turbo Ender-3 CR10

and I don't know which one to buy.

Only today I learned what drivers are.

5. When I decide what to buy, I need advice on how to assemble and set it up.

6. What Firmware should I download and how to install it.

I need step-by-step advice on how to proceed and what to do.