Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 4110

Hybrid View

  1. 04-16-2016, 03:50 AM #1
    Warren O'neill
    Warren O'neill is offline
    Student
    Join Date
    Mar 2016
    Posts
    29
    Quote Originally Posted by jfkansas View Post
    how bad was it bent? I have seen printers that were just fine after loosening up the screws top and bottom then run the platform up and down a little. Tighten back up and all good.
    Ok so i have tried what you suggested but its still getting stuck.
    you can see the bend in the rod as it turns

    Not to worry there is a new one on the way
    Reply With Quote Reply With Quote
  2. 04-16-2016, 09:39 AM #2
    jfkansas
    jfkansas is offline
    Super Moderator
    Join Date
    Apr 2014
    Location
    KS
    Posts
    907
    Add jfkansas on Thingiverse
    It will also help if you take the bearing out of the top of the lead screw where it fits into the plastic.

    Quote Originally Posted by Warren O'neill View Post
    Ok so i have tried what you suggested but its still getting stuck.
    you can see the bend in the rod as it turns

    Not to worry there is a new one on the way
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules