Quote Originally Posted by DarkAlchemist View Post
I am not sure what is going on but my G29 is screwy and I only just found it out. I can do a G28 or even a G30 but only with G29 does this happen. What happens is it will go scanning my bed then finish. Alright, but from then on any direction I tell the head to move, via pronterface, makes all axis move simultaneously by that much. When I do a G28, or a G30, the issue disappears. Almost acts as if something is left on that shouldn't be. Any ideas what is going on?
Did you install Roxy's enhanced bed levelling code, or are you just using the standard ABL changes to the Configuration.h? If you are using Roxy's code, did ABL work properly before you added the enhancements?