This is some pretty extreme curling for PLA.

I would suggest upping your print temperature a little bit. I print PLA at 215.

I use 65C for layer 1 bed temp.
30C after layer one.

Are you wiping your blue tape with rubbing alcohol before you print? That makes a huge difference to me.

As always, make sure your bed is very level or you will have issues.

If none of the above help, you might have a low/high spot in you bed - I do. Try moving your print to a different area of the bed and the issue may go away. Impact from a high or low spot can be reduced if you upgrade to a glass bed.