Results 1 to 10 of 42
Hybrid View
-
04-29-2015, 11:47 AM #1
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Here is my class 6 8gb config and it works fine:
[Vendor]
CIPATH=/DCIM/100__TSB/FA000001.JPG
APPMODE=5
APPSSID=loft
APPNETWORKKEY=
VERSION=F24A6W3AW1.00.04
CID=02544d53573038470750016c4e00c901
PRODUCT=FlashAir
VENDOR=TOSHIBA
APPNAME=printer01
MASTERCODE=0013723642c6
LOCK=1
UPLOAD=1
UPDIR=/
APPAUTOTIME=0
DHCP_Enabled=NO
IP_Address=192.168.0.55
Subnet_Mask=255.255.255.0
Default_Gateway=192.168.0.1
Preferred_DNS_Server=192.168.0.1
-
04-29-2015, 12:25 PM #2
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
Thanks. I will try that tonight.
-
04-30-2015, 09:42 PM #3
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
Well, I finally got the mac to show up as an attached device in my router, but there is no IP shown.
When I connect to the assigned IP/upload.cgi, I get the upload page, but it refuses to upload the file, unlike when I connected directly to the card.
ETA: it finally uploaded the file Yay!
Just took a long time.
Not sure why the IP won't display in the router table.
ETA: seems to disconnect before or after uploading the file.
Thanks Mj!Last edited by robosmith; 04-30-2015 at 09:59 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion