flashprint 4.1.0

[fred_dot_u]

I'm not sure what you mean by "top panel just disappeared." A screen shot may be helpful for that reference.

Meshmixer determined four flaws on the head and repaired them. Simplify3D also identified problems, but I don't use S3D for repairs. The Meshmixer repaired model showed only self-intersecting surfaces, which may be a hint to the overall problem.

PrusaSlicer has determined that there's a problem about the 6.5 mm level. It appears that the wall thickness is too small. The model is smaller than 8 x 8 x 6 mm and that may contribute to the trouble. When scaled up by 10x, the problems disappear.

If it is not your creation, it's possible that the artist responsible overlooked a few important characteristics for 3D printing.

[ronisegoly]

thanks
this is not my model, I downloaded it
it is tiny so I had to scale it significantly, did it with printing SW
I retried now, the issue is with size probably
when I scale to 1000% I can send to printer, and when I scale to 1600% I cannot (both screenshots)
I was expecting that if I have size issue I will see indication on, and in any case it is less than my machine boundarieshttps://www.dropbox.com/s/oumjslbu479s4x6/Screenshot%202020-01-25%2006.12.46.png?dl=0https://www.dropbox.com/s/vxgs745kyfji034/Screenshot%202020-01-25%2006.14.40.png?dl=0https://www.dropbox.com/s/e0elhkoyw59seeo/Screenshot%202020-01-25%2006.21.45.png?dl=0

I'm not sure what you mean by "top panel just disappeared." A screen shot may be helpful for that reference.Meshmixer determined four flaws on the head and repaired them. Simplify3D also identified problems, but I don't use S3D for repairs. The Meshmixer repaired model showed only self-intersecting surfaces, which may be a hint to the overall problem.PrusaSlicer has determined that there's a problem about the 6.5 mm level. It appears that the wall thickness is too small. The model is smaller than 8 x 8 x 6 mm and that may contribute to the trouble. When scaled up by 10x, the problems disappear.If it is not your creation, it's possible that the artist responsible overlooked a few important characteristics for 3D printing.