Rumba and Auto-Bed level

[jasay]

I thought maybe there would be a difference in this section of the configuration.h file, but tsteever's matches Colins.

#define INVERT_X_DIR true    // for Mendel set to false, for Orca set to true#define INVERT_Y_DIR false    // for Mendel set to true, for Orca set to false
#define INVERT_Z_DIR true     // for Mendel set to false, for Orca set to true
#define INVERT_E0_DIR false   // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_E1_DIR false    // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_E2_DIR false   // for direct drive extruder v9 set to true, for geared extruder set to false

[Chadd]

I am using the firmware that tsteever posted with just a few mods to it and it works fine on my 12" so it has to be a connector reversed issue.

If it worked previously I wonder if someone went into the FW that was loaded and changed it instead of reversing the connector.

I thought maybe there would be a difference in this section of the configuration.h file, but tsteever's matches Colins.

#define INVERT_X_DIR true    // for Mendel set to false, for Orca set to true#define INVERT_Y_DIR false    // for Mendel set to true, for Orca set to false
#define INVERT_Z_DIR true     // for Mendel set to false, for Orca set to true
#define INVERT_E0_DIR false   // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_E1_DIR false    // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_E2_DIR false   // for direct drive extruder v9 set to true, for geared extruder set to false