Results 1 to 10 of 50
Thread: The curse of ABS (Warping)
Threaded View
-
10-20-2013, 03:02 PM #11
The solution to this is simple, turn up the heat on your bed, i had similar problems in the past, but then tried to print at 120c, it worked like a charm, the plastic keeps softer then, and does not "collect" the warping forces in the print.
i set my first layer temp to 100c and the other layers to 120c, that way i dont have to wait forever for the bed to get to temerature and the printing to begin.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion