New editing restrictions?

[Eddie]

Hmm perhaps users aren't allowed to edit messages. I will have to check into this.
Eddie

[printbus]

Hmm perhaps users aren't allowed to edit messages. I will have to check into this.
Eddie

Thanks for looking into it. Something is going wrong. If it helps, the post I created today and immediately could not edit is this one - http://3dprintboard.com/showthread.p...ll=1#post44061. I still can't edit that post. I can bring up the edit window, but get the vbulletin popup regarding too few characters in the message when attempting to save changes.

There are other posts I've recently added, and other old posts that I've recently edited, that I can still edit fine. The issue seems almost random - that some posts can be edited and some cannot. And again, the vbulletin message that says a message is less than 10 characters when attempting to save the edit makes little sense.

EDIT: This post, for example, I can edit fine.