Wax Filament

[3ddplas]

sorry sir, I don't look through all this thread, sorry for my rude come in.
it is a real wax filament, not plastic, process temperature for extruder is only 100deg.
I think call it PE-wax filament will be more accurate, it must can be melt to flow and can be extrude to be filament ,much like plastic, a low melt point plastic

[Wes@MachWax]

sorry sir, I don't look through all this thread, sorry for my rude come in.
it is a real wax filament, not plastic, process temperature for extruder is only 100deg.
I think call it PE-wax filament will be more accurate, it must can be melt to flow and can be extrude to be filament ,much like plastic, a low melt point plastic

My mistake then. It was the string pattern at the bottom of the solo Buddha that made me think that.

Great job on the prints. What printer are you using? What resolution were the Buddhas printed at? The cast part came out well too.