Bonded Heat bed for 12"

[lakester]

Thx for sharing your research and results Chadd.

When you did the PID calibration..., how did you store the calibration numbers? In the firmware? NVRAM? ???

[rhonal89]

Also you should open up a new thread and write up a instruction for us all that are looking on doing this. Because it seem cheap and why not do it if it would improve on print quality. Thanks.

[Chadd]

Also you should open up a new thread and write up a instruction for us all that are looking on doing this. Because it seem cheap and why not do it if it would improve on print quality. Thanks.

I will make a separate thread dealing with the PID setup.

[rhonal89]

Thank You!!! Hope this helps you greatly. And those upgrade you meaning on doing. Will truly helps when you get there.

[Chadd]

You enter them in your Configuration.h file. You also need to enable PID for the heat bed. I started a separate thread on the PID setup.

http://3dprintboard.com/showthread.p...7322#post67322

Thx for sharing your research and results Chadd.

When you did the PID calibration..., how did you store the calibration numbers? In the firmware? NVRAM? ???