Results 1 to 10 of 21
Threaded View
-
06-02-2014, 10:13 PM #8
- Join Date
- Feb 2014
- Posts
- 11
Annndd the new motherboard didn't do anything.... Problem still exists.
Ruled out the print file, as they printed the same x3g that I am trying to print (except they printed it successfully).
Any ideas???????????????????????? I'm about to give up. Could a bad stepper motor cause a freeze up? - the printer automatically reboots 80% of the time it freezes. The other 20% it will freeze and all heaters will stay on (dangerous if left unattended).
I put a thermo gun on the Y-axis stepper motor, it got to about 110 degrees F until print froze. Not sure if that is ok or not.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help