Raft is perfect then its a nightmare

[Whaitey]

What do you mean? I didn't do anything special, just the usual thing, like filament type, nozzle 0.4mm.

And to be honest i don't have a case for my printer, i'm about to build one as my heated bed cant go over 100 celsius.

[LambdaFF]

Hi Whaitey, I think that while the advice of Lucky is good, you need to be a bit more systematic about all this.

I would suggest you to :
- first set precisely your Z0 gap, because otherwise any test you do on the flow rate will be biased by this. Do you have calibrated shims ?
- then set your flow rate right : there are tutorials for that.
- additionnaly, I would recommend checking your filament diameter, to be sure.

have a nice day

[Sebastian Finke]

What do you mean? I didn't do anything special, just the usual thing, like filament type, nozzle 0.4mm.

And to be honest i don't have a case for my printer, i'm about to build one as my heated bed cant go over 100 celsius.

Sounds like you haven't calibrated it. Go to the flashforge forum and look fir the stickied Sailfish manual thread. In the first post is a link to the manual. It will be very helpful, even if you aren't running Sailfish. Especially chapter 5!