Marlin firmware fork for MakerFarm i3v w/ auto bed level & Roxy's enhancements

[tsteever]

Yes, I am heating the bed. With the old firmware I would adjust the offset in the menu system and then put that number in the firmware. This saved a few extra steps. The issue I am having is the homing command and the bed leveling command are giving me two different nozzle heights.

[uncle_bob]

Yes, I am heating the bed. With the old firmware I would adjust the offset in the menu system and then put that number in the firmware. This saved a few extra steps. The issue I am having is the homing command and the bed leveling command are giving me two different nozzle heights.

Hi

The homing command is going to take you to the point that the end stops trigger. For X and Y that's probably ok. For Z ... not so much. The old approach was to use the Z probe as the Z end stop. Same probe, same height, problem solved.

Bob