Qidi Tech 1 - Replicator 1 clone

[wirlybird]

On mine I have to shim the right side under the heat bar that bolts to the carriage about the thickness of one sheet of paper to raise the right nozzle slightly. My guess is the carriage is just off on that side. Maybe it bowed down a bit - I don't know but it's just plastic so who knows. My right nozzle was just enough lower to catch once and a while on something. Shimming was the most suggested way to compensate. It has worked fine.

Interesting. How is that even possible? Both assemblies rest on the carriage. Near as I could tell there was no sort of wiggle room like you have with the MP Mini, where there was some room between the plastic tube and the feed hole.

[Merijeek]

On mine I have to shim the right side under the heat bar that bolts to the carriage about the thickness of one sheet of paper to raise the right nozzle slightly. My guess is the carriage is just off on that side. Maybe it bowed down a bit - I don't know but it's just plastic so who knows. My right nozzle was just enough lower to catch once and a while on something. Shimming was the most suggested way to compensate. It has worked fine.

Awesome. I'll give that a shot when I get home. Assuming my bright orange Pac Man ghost (left Extruder!) is finished printing when I get there. 20+ hours!

Which piece, exactly, is the heat bar?

[wirlybird]

Awesome. I'll give that a shot when I get home. Assuming my bright orange Pac Man ghost (left Extruder!) is finished printing when I get there. 20+ hours!

Which piece, exactly, is the heat bar?

I'll post a pic in a little while.

[wirlybird]

Awesome. I'll give that a shot when I get home. Assuming my bright orange Pac Man ghost (left Extruder!) is finished printing when I get there. 20+ hours!

Which piece, exactly, is the heat bar?

Here you go.

[IMG][/IMG]