[MARLIN] 1.1.2 - DIY kit - Repetier-Host - Configure Print Area and Zero - Help!

[Roxy]

If it has Marlin v1.1.2 firmware loaded... You ought to update to the latest version.

[Freedom]

If it has Marlin v1.1.2 firmware loaded... You ought to update to the latest version.

Tell you what. I did this today, and got it updated to 1.8.3! This came with other useful wisdom to me, as for example that I can actually upload firmware to the printer. I thought it was completely controlled by computer, so this explains why I had so little function of the motors and such. This solved my Y-axis problems, as I could now invert the Y-axis to count the other way around. This solved everything.

Now I am basically only struggling with leveling my bed with my X-axis. I have tried for a couple of hours now without luck, but I'll keep Google that, and I'll eventually figure it out.

Thank you for the help though!

[Roxy]

Now I am basically only struggling with leveling my bed with my X-axis. I have tried for a couple of hours now without luck, but I'll keep Google that, and I'll eventually figure it out.

Go into Configuration.h and turn on the UBL bed leveling option... I'll help you get everything up and running....