Quote Originally Posted by Warmaster View Post
Ok I threw the autolevel sensor away since it was not accurate at all. Its rated 6-36v and when measure from board pins it gives 4,94v only so I guess the accuracy goes way too low. Led lights ok etc but i noticed that tiniest nudge on same spot might turn it off.

I put in a microswitch like on other axis and flashed firmware to disable the autolevel bed feature.
If you bring up the UBL Bed Leveling System, the accuracy of the Z-Probe doesn't really matter. If the probe is super accurate, it save 10 or 15 minutes of setup time. But even with a horrible Z-Probe (or no Z-Probe) you can generate a mesh and fine tune it in 30 or 40 minutes. And from then on... Your "Good to Go".