Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Threaded View

  1. 01-11-2016, 11:22 AM #5
    LuckyImperial
    LuckyImperial is offline
    Technologist LuckyImperial's Avatar
    Join Date
    May 2015
    Location
    Campbell, CA
    Posts
    162
    Quote Originally Posted by BrokerRon View Post
    I assume the firmware is already installed., its a I3 . I can not save ti the SD card......I get an error saying I can not save to the SD. Uses good ones and the same problem.
    I am connected to the Repetair server, but my printer is NOT connected to the server. Still trying to connect the printer.
    The Arduino board likely did come with firmware pre installed, but you will need to become comfortable on how to upload it on your own:

    http://solidutopia.com/marlin-firmwa...r-guide-basic/


    Don't use Repetier Server. You need to connect a cable directly from your computer to the Arduino board and then use prontrface/Repetier Host to connect to the printer.
    Last edited by LuckyImperial; 01-11-2016 at 02:47 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules