Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 10

Hybrid View

  1. 01-26-2016, 11:22 PM #1
    Mjolinor
    Mjolinor is offline
    Senior Engineer
    Join Date
    Jun 2014
    Location
    Burnley, UK
    Posts
    1,662
    This is not a new thing to 3D printing, it has been a problem for ever in engineering. It is all covered under the general area of "limits and fits" and is always catered for on the drawing board before you get anywhere near making the things.
    Reply With Quote Reply With Quote
  2. 01-27-2016, 12:37 AM #2
    GMIJackso
    GMIJackso is offline
    Student
    Join Date
    Jan 2016
    Posts
    5
    Quote Originally Posted by Mjolinor View Post
    This is not a new thing to 3D printing, it has been a problem for ever in engineering. It is all covered under the general area of "limits and fits" and is always catered for on the drawing board before you get anywhere near making the things.
    Right... So, any tips or ideas on the easiest/best way to deal with this problem on the drawing board that is commonly used 3D design software frequented by 3D printing hobbyists?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules