Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 42

Hybrid View

  1. 10-06-2016, 11:55 AM #1
    Todd-67
    Todd-67 is offline
    Engineer-in-Training
    Join Date
    Apr 2015
    Location
    Northern Ohio
    Posts
    198
    Quote Originally Posted by djprinter View Post
    My guess would be that the filament isn't freely coming of the spool.

    But your temperature is also low for ABS. I'd suggest printing at 240.
    That is what I was wondering as well. I have had some materials that require a fair amount more heat than others of the same type.
    Reply With Quote Reply With Quote
  2. 10-06-2016, 12:32 PM #2
    wirlybird
    wirlybird is offline
    Super Moderator
    Join Date
    Jun 2016
    Location
    Oklahoma
    Posts
    904
    Quote Originally Posted by Todd-67 View Post
    That is what I was wondering as well. I have had some materials that require a fair amount more heat than others of the same type.
    If you don't go to all metal hot ends you will start to have issues with the PTFE tube once you start going over 230. I'd check that out first to see.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules