Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 22

Hybrid View

  1. 05-25-2015, 07:03 PM #1
    PyramidDave
    PyramidDave is offline
    Technologist
    Join Date
    Nov 2014
    Location
    Brevard, NC
    Posts
    182
    Does anyone know what that small hole at bottom center of the X-Idler plate is for? Does anyone use that hole for some purpose?
    Reply With Quote Reply With Quote
  2. 05-25-2015, 07:36 PM #2
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Quote Originally Posted by PyramidDave View Post
    Does anyone know what that small hole at bottom center of the X-Idler plate is for? Does anyone use that hole for some purpose?
    Don't know of anyone who has used it. When I built my i3v-8, I figured it might have originally been for a screw to be used with the original Z-endstop switch, similar to the screw on the Y-bed used with the Y-endstop. It's not in the right position for even that, but that's the best I could come up with.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules