Rumba and Auto-Bed level

[Roxy]

Hope this isn't considered a thread hijack..., but..., question:

When ABL is enabled, and once printing begins, is the Z correction applied continuously throughout the print, or is it disabled after the first few layers? Programmable option?

Thx!

Currently, it is through the whole print. But there is talk about making the nozzle follow the contour of the bed (to handle high and low spots) and having that phase out over some number of layers. That code isn't there right now.

[rhonal89]

That would be great. Because currently the way am set up right now. Is having to print in one conner of the bed were the prints layer looks better that the other spots.

Currently, it is through the whole print. But there is talk about making the nozzle follow the contour of the bed (to handle high and low spots) and having that phase out over some number of layers. That code isn't there right now.

[lakester]

OK..., thx.

Currently, it is through the whole print. But there is talk about making the nozzle follow the contour of the bed (to handle high and low spots) and having that phase out over some number of layers. That code isn't there right now.

[Roxy]

Currently, it is through the whole print. But there is talk about making the nozzle follow the contour of the bed (to handle high and low spots) and having that phase out over some number of layers. That code isn't there right now.

These features are now fully enabled and working....