Filament not sticking to bed (newbie)

[cj7hawk]

I find my Dreamer bed ( same ) is TOO sticky if anything.... It takes a LOT of effort to get anything off of it. Especially if it has a large flat surface and is printed without a raft... I'd guess leveling is the problem also, even though you already have more hours on the printer than I do.

[Roberts_Clif]

I find my Dreamer bed ( same ) is TOO sticky if anything.... It takes a LOT of effort to get anything off of it. Especially if it has a large flat surface and is printed without a raft... I'd guess leveling is the problem also, even though you already have more hours on the printer than I do.

In cases where the filament sticks too securely raise the nozzle slightly so as to have less adhesion.