Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 27

Hybrid View

  1. 03-28-2016, 11:15 AM #1
    Mjolinor
    Mjolinor is offline
    Senior Engineer
    Join Date
    Jun 2014
    Location
    Burnley, UK
    Posts
    1,662
    Quote Originally Posted by Odys View Post
    There are 3d pens that can print with ninjaflex so i dont see the reason to block the nozzle.If you refer to the epoxy coating used as adhesive that you apply after in the surfaces of the printed objects that you want to glue.
    This thread is about joining pieces of filament before use so that you can use all the bits you have about the place and your suggestion is not a good solution for that. The epoxy would trash the nozzle.
    Reply With Quote Reply With Quote
  2. 03-28-2016, 11:24 AM #2
    Odys
    Odys is offline
    Student
    Join Date
    Feb 2016
    Posts
    6
    Quote Originally Posted by Mjolinor View Post
    This thread is about joining pieces of filament before use so that you can use all the bits you have about the place and your suggestion is not a good solution for that. The epoxy would trash the nozzle.
    O sorry my bad you are right
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules