Results 1 to 10 of 25
Hybrid View
-
01-31-2015, 01:44 PM #1
- Join Date
- Aug 2014
- Posts
- 9
it was some setting in slicer that was wrong. i found a other config file and now it is 0.1 to small
but i have an other problem
how can i get rid of the rippels there is on the 11 and 12,
i dont mean the layer lines, i mean that the layer lines arent aligned
i have played around with the extruder multiplier, filament width (the filament had some diff), micron reselution. seems to bi a bit better when i tried to prit att 400 microns.
Last edited by Melzk; 01-31-2015 at 02:19 PM. Reason: add text and images
-
04-17-2015, 08:31 AM #2
- Join Date
- Jan 2015
- Posts
- 68
Did you ever get those layers fixed up Melzk?
-
04-17-2015, 04:03 PM #3
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
It looks like you have Z wobble/backlash. Are your Z rods constrained at the top and bottom? Do they sway as the Z goes up and down?
You might look into using this http://www.thingiverse.com/thing:769057 on each side to see if that gets rid of the ripples. Use one spring and two nuts in each.Last edited by AbuMaia; 04-17-2015 at 04:54 PM.
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials