Thanks for the help..
1) Yes it all had dislodged and was stuck on the nozzle in one piece. So nothing was on the bed as it was moving around.
2) Yes it did do.. not turned it on since as I thought I should get some advice first on what to do next..
3) The red tape that came on the printer.. like painters tape yes..


100%.. ah ok.. will do in future.. thanks again.


Ok.. yes I'll not have the paper grip so tight the next time I align.. I guess I should have erred on the side of caution for the first run anyway.. better to be too far, than too close perhaps..

EDIT: Ah missed your reply EagleSeven.. ok will do that now... Is there any substance I should use? I don't have a lot in the house at the mo but can venture out.. I do have 99% isopropyl alcohol if that's any help...


No worries.. I'll not let it discourage me.. Life would be boring if everything just worked perfectly.. you wouldn't have the fun of learning!




So.. you were me.. what would your next step be? Unscrewing nozzle for a clean? Running the unload sequence?