Anyone used Printbite surface ?

[Talon 3D]

One thing I'm wondering is how I'm going to remove the QIDI blue tape thing to install the Printbite.

[DaveB]

One thing I'm wondering is how I'm going to remove the QIDI blue tape thing to install the Printbite.

Here is one way of removing it:

https://youtu.be/KaFMr4gx_tc

[DaveB]

One thing I'm wondering is how I'm going to remove the QIDI blue tape thing to install the Printbite.

https://youtu.be/EkIwv_uEv3A

Sorry, picked up the wrong link

[Talon 3D]

Nice, thank you.
That guy has a whole bunch of QIDI upgrade parts you can make on ThingiVerse. I made several of them so far. He didn't have tipping enabled though. He should he is really helpful.

https://youtu.be/EkIwv_uEv3A

Sorry, picked up the wrong link

[DaveB]

Nice, thank you.
That guy has a whole bunch of QIDI upgrade parts you can make on ThingiVerse. I made several of them so far. He didn't have tipping enabled though. He should he is really helpful.

Cncartist is indeed most helpful. I have printed / adapted a great many of his designs for use with my QiDi. Of them all, my favorite is the hanging parts bin. They take a while to print, but I use them every single day. (I liked them so much I made two.)

[Talon 3D]

Nice!!
I have made the center plug under the bed, the door clip and I am making the other interior caps today.
I have not gotten to the parts bin, I just finished a mount system for my RPi3 and Pi Cam and mounted them up a few mins ago. I had my OctoPi system hanging all over the place now it is nice and neat, just have to make ribbon cable clips and all will be good. I will upload pics later.

Cncartist is indeed most helpful. I have printed / adapted a great many of his designs for use with my QiDi. Of them all, my favorite is the hanging parts bin. They take a while to print, but I use them every single day. (I liked them so much I made two.)

[DaveB]

Nice!!
I have made the center plug under the bed, the door clip and I am making the other interior caps today.
I have not gotten to the parts bin, I just finished a mount system for my RPi3 and Pi Cam and mounted them up a few mins ago. I had my OctoPi system hanging all over the place now it is nice and neat, just have to make ribbon cable clips and all will be good. I will upload pics later.

This one is not by cncartist, but is an exceptionally useful hinge for the QiDi's front door. http://www.thingiverse.com/thing:1697406 If you slide it to the right it locks the door up in the open position, rotate down by 30 degrees and you can lift to remove the entire door. Kind of made the door clip unnecessary though.

[Talon 3D]

These look handy indeed.

This one is not by cncartist, but is an exceptionally useful hinge for the QiDi's front door. http://www.thingiverse.com/thing:1697406 If you slide it to the right it locks the door up in the open position, rotate down by 30 degrees and you can lift to remove the entire door. Kind of made the door clip unnecessary though.